5 Effective Cleaning Techniques When using a Solvent Trap Kit

To keep your firearm functioning effectively and firing safely, you need to inspect and clean your gears regularly. This is due to the tiny explosions leaving residue and sediments in the chamber each time you pull the trigger. Therefore, to avoid dangerous malfunctioning, you need to clean your firearm after every use.

When cleaning a firearm, the most preferred option is to opt for a solvent trap kit. It’s a cleaning accessory designed to keep the fluids in your tool from harming the environment while ensuring your firearm is highly performing and fully functional.

As a responsible firearm owner, you are probably ready to gather every piece of information needed to keep your firearm clean and ready to run. But, gladly, there are ways you can get more from your solvent trap kit.

In this article, we will be giving five effective cleaning techniques when using a solvent trap kit.

1. Use the cleaning rod rightly

Sometimes, while using the solvent trap kit to clean your firearm, you still find the debris redeposited in the barrel regardless of how much you try. This happens when you are not using the bore brush and cleaning rod rightly.

While sending the rod and patch holder into the barrel to push the solvent-soaked patch to exit into the solvent trap, you should not pull it back. Doing this will redeposit all the debris you have cleaned off back into the firearm.

2. Run the patch through multiple times

Depending on how you have used the firearm, running the patch through the barrel once might not be enough to get all the dirt out.

Attach the patch holder to the cleaning rod and send more cotton patches soaked with solvent through the bore as many times as possible to pick up every dirt until it comes out clean. After this, you can run a dry patch to pick up the moisture in the barrel and find any build-up that you may have missed.

3. Use a muzzle guard

It’s advisable to work from the back of the bore while the solvent trap is attached to the firearm. However, if you have to pass the cleaning rod through the front, use a muzzles guard. It helps to prevent the rod from damaging the muzzle. A tampered muzzle can cause your firearm to malfunction.

4. Switch between patches and bore brush

Instead of the patches alone, use the bore brush a few times to find and loosen any debris in the firearm. Attach the bore brush to it, and return it into the barrel.

Move the bore brush back and forth about 3 or 4 times inside the bore to reach the entire length of the bore and loosen any debris.

5. Use lubricant

It’s advisable to include lubrication in your cleaning process. Lubricants help prevent rust from getting to any part of the firearm. So, after you are sure that you have gotten all the debris from the barrel, apply solvent to a cleaning brush and brush all the parts of the tool, especially the action parts. Wipe it thoroughly with a clean cloth.

Now, using a light coating, lubricate the moving parts of the action. Stick to using a small amount since heavy coating can get gummy and attract more debris. Apply a few drops of lubricant to a cotton mop and attach it to the cleaning rod. Run the rod through the bore to leave the inside lightly coated.

If you are interested in buying solvent traps then visit right away.

Show More

Related Articles

Leave a Reply

Back to top button